SG10 Type H-Class Insulation Dry-Type 11Kv 33Kv Power Transformer

1.SG10 Type H-Class Insulation Dry-Type 11Kv 33Kv Power Transformer

01) The core is made of cold-rolled silicon steel sheet with high magnetic permeability, and the structure is drawn plate;

The magnetic circuit is short, the loss and noise level is low;

02) Winding adopts compression line, small loss, strong short-circuit resistance;

03) The active part adopts special pressing mode, and axial compression is reliable;

04) The oil tank is bell shaped, full folding plate structure, good appearance, easy maintenance;

05) The capsule type oil container is used to minimize the aging of oil.

06) Local discharge: the apparent discharge at 1.5 times the rated voltage is less than 80pC;

07) Noise :63MVA and below products less than 58dB(AN);

08) Power loss: no-load loss is 30% lower than IEC standard;

09) Reliability: No damage or oil leakage occurred to all in-service products;

10) Short circuit resistance: SFZ11-5000/132 products successfully passed the national short circuit resistance test

Transformer quality supervision and inspection center and through the Netherlands "KEMA" quality control system.

1)Simple maintenance: seldom need any maintenance.
2)They are pollution-free
3)They are used in the areas of contaminated and damped
4)They are easier to Install.
5)They have long servie life because of the dielectric heating & low thermal
6)Protects the property & people
7)For short circuit currents, they have high resistance
8)Performance is excellent
Capacity is high to support overloads